virtio: use virtio_device_ready() in virtio_device_restore()

After waking up a suspended VM, the kernel prints the following trace
for virtio drivers which do not directly call virtio_device_ready() in
the .restore:

    PM: suspend exit
    irq 22: nobody cared (try booting with the "irqpoll" option)
    Call Trace:
     <IRQ>
     dump_stack_lvl+0x38/0x49
     dump_stack+0x10/0x12
     __report_bad_irq+0x3a/0xaf
     note_interrupt.cold+0xb/0x60
     handle_irq_event+0x71/0x80
     handle_fasteoi_irq+0x95/0x1e0
     __common_interrupt+0x6b/0x110
     common_interrupt+0x63/0xe0
     asm_common_interrupt+0x1e/0x40
     ? __do_softirq+0x75/0x2f3
     irq_exit_rcu+0x93/0xe0
     sysvec_apic_timer_interrupt+0xac/0xd0
     </IRQ>
     <TASK>
     asm_sysvec_apic_timer_interrupt+0x12/0x20
     arch_cpu_idle+0x12/0x20
     default_idle_call+0x39/0xf0
     do_idle+0x1b5/0x210
     cpu_startup_entry+0x20/0x30
     start_secondary+0xf3/0x100
     secondary_startup_64_no_verify+0xc3/0xcb
     </TASK>
    handlers:
    [<000000008f9bac49>] vp_interrupt
    [<000000008f9bac49>] vp_interrupt
    Disabling IRQ #22

This happens because we don't invoke .enable_cbs callback in
virtio_device_restore(). That callback is used by some transports
(e.g. virtio-pci) to enable interrupts.

Let's fix it, by calling virtio_device_ready() as we do in
virtio_dev_probe(). This function calls .enable_cts callback and sets
DRIVER_OK status bit.

This fix also avoids setting DRIVER_OK twice for those drivers that
call virtio_device_ready() in the .restore.

Fixes: d50497e ("virtio_config: introduce a new .enable_cbs method")
Signed-off-by: Stefano Garzarella <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Michael S. Tsirkin <[email protected]>

Author: stefano-garzarella

drivers/virtio/virtio.c

@@ -526,8 +526,9 @@ int virtio_device_restore(struct virtio_device *dev)
 			goto err;
 	}
 
-	/* Finally, tell the device we're all set */
-	virtio_add_status(dev, VIRTIO_CONFIG_S_DRIVER_OK);
+	/* If restore didn't do it, mark device DRIVER_OK ourselves. */
+	if (!(dev->config->get_status(dev) & VIRTIO_CONFIG_S_DRIVER_OK))
+		virtio_device_ready(dev);
 
 	virtio_config_enable(dev);